I am still unable to find the .config directory?
I am aware "." is for hidden locations, hence why I use command $ls -al rather than $ls.
Further research says config is if /boot/firmware, however I still don't find the config directory, just a config.txt file?
I am aware "." is for hidden locations, hence why I use command $ls -al rather than $ls.
Further research says config is if /boot/firmware, however I still don't find the config directory, just a config.txt file?
Code:
raspberrypi5@raspberrypi:/boot/firmware $ cat config.txt # For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[all]#NVMe config for faster speedsdtparam=pciex1_gen=3Statistics: Posted by eiger3970 — Thu Sep 26, 2024 6:52 am