Hi, I'm using a headless Raspberry pi 3, I just installed a fresh system on new SD card and it won't connect. I've tried thrice to set it up using the recommended imager, never succeed. It seems like it does not remember the wifi password, as the field is empty. I absolutely believe I can wire it up to peripherials, type it in and click it through, but I have none (*tiny display with uncalibrated touch), only my laptop, so I need headless setup. The old OS on previous SD worked "near perfectly", so I doubt its fault on HW side. I've even tried searching through the files in boot partition, but as stated in Documentation here: (https://www.raspberrypi.com/documentati ... -network-2) -> "Previous versions of Raspberry Pi OS made use of a wpa_supplicant.conf file which could be placed into the boot folder to configure wireless network settings. This functionality is not available from Raspberry Pi OS Bookworm onwards." -> It seems like its no longer possible. I'm gonna ask anyway - is there a way to edit some wifi config files on the SD, after the OS is installed? It's tiring to renew whole installation when I need to change only few settings. And what steps should I take in order to make it connect? Thanks in advance and many apologies for this wall of text.
Statistics: Posted by mksh — Sun Mar 09, 2025 1:06 pm