Hi there,
I just got a raspberry pi zero 2 w that I was hoping to run klipper on and control my 3d printer. However, after following countless tutorials, I had no luck. I used the official pi imager to write both mainsail and pi os (lite and normal) and then I insert the micro sd card into the pi and the light starts flashing. After about 3-5 minutes it stops and a consistent light is shown on the pi. I have tried to use putty to connect the pi via ssh with no luck. I looked on my router each time and the pi was not connected.
What do I do?
I just got a raspberry pi zero 2 w that I was hoping to run klipper on and control my 3d printer. However, after following countless tutorials, I had no luck. I used the official pi imager to write both mainsail and pi os (lite and normal) and then I insert the micro sd card into the pi and the light starts flashing. After about 3-5 minutes it stops and a consistent light is shown on the pi. I have tried to use putty to connect the pi via ssh with no luck. I looked on my router each time and the pi was not connected.
What do I do?
Statistics: Posted by taranpar — Sat Feb 15, 2025 2:46 am