Hey everyone,
I'm having trouble with my Raspberry Pi Pico W. Earlier today, it was working perfectly when plugged in, it would mount as a USB drive. However, out of nowhere, it stopped showing up, and the LED on the board no longer turns on.
I tried re-flashing the same CircuitPython UF2 file, and the RPI-RP2 drive appeared. However, after flashing, the drive disappeared and didn’t remount. I've been stuck in this state ever since.
So far, I’ve tried:
- Using flash_nuke
- Flashing different UF2 files, including MicroPython
- Testing another Pico board (Tested 2 out of 3, were previously working and should not be defective)
- Trying different USB ports and flashing from a Raspberry Pi 4B
The only thing I haven’t attempted is a firmware or bootloader reflash, but I’m unsure if that’s the issue. My USB cable seems to be fine, but I can’t completely rule it out.
Any help or suggestions would be greatly appreciated!
Thanks.
I'm having trouble with my Raspberry Pi Pico W. Earlier today, it was working perfectly when plugged in, it would mount as a USB drive. However, out of nowhere, it stopped showing up, and the LED on the board no longer turns on.
I tried re-flashing the same CircuitPython UF2 file, and the RPI-RP2 drive appeared. However, after flashing, the drive disappeared and didn’t remount. I've been stuck in this state ever since.
So far, I’ve tried:
- Using flash_nuke
- Flashing different UF2 files, including MicroPython
- Testing another Pico board (Tested 2 out of 3, were previously working and should not be defective)
- Trying different USB ports and flashing from a Raspberry Pi 4B
The only thing I haven’t attempted is a firmware or bootloader reflash, but I’m unsure if that’s the issue. My USB cable seems to be fine, but I can’t completely rule it out.
Any help or suggestions would be greatly appreciated!
Thanks.
Statistics: Posted by y9k — Mon Feb 10, 2025 6:11 am